Xbox 360 Hacking - DGX v1.1S On Sale Now

February 9th, 2013, 14:24 Posted By: wraggster

News via http://team-xecuter.com/dgx-v1-1s-on-sale-now/

After the phenomenal success of our DGX product, we listened to a great deal of feedback from our loyal userbase and have implimented some changes to the design to make the DGX perform even better than before – especially for Trinity boards.
DGX V1.1S change log:

• Added 70cm 24WG POST_OUT Wire
• Added a ceramic cap option (Point C29) between D and GND (same as CR3 Pro) – included an optional 10pf ceramic cap
• Added a selectable 5ohm and 10ohm resistor to post_out (simple solder jumpers 1 Closed: 10ohm, 2 Closed: 5ohm, 3 Closed: 0ohm Default)
• Added a a grounded IPEX socket (Point J1) for CPU_RST (10cm IPEX cable included)
• Larger solder pads and stronger vias (C D E F 5v GND)
• Removed JTAG pin header (Programming is not required – some users tried to program their DGX and damaged it)
• Optimized code for enhanced Trinity performance. DGX 1.1 would boot the worst Trinity we had in 30 seconds (v1.0 booted in 2 minutes)
• My preferred settings for Trinity were: D: 10cm IPEX to R4D4, C: 70cm 24AWG Wire , 10pf Cap Installed, 0ohm (Default)
• My preferred settings for Corona were: D: 10cm IPEX to C5R11, C: Default wire, No Cap Installed, 10ohm

Remember that there may be fake DGX out there – it goes without saying that they are cheap garbage and you should stay away. Every official Xecuter product has a serial code – you should claim ownership of the code at serial.xecuter.com

There are 0 comments - Join In and Discuss Here